The A710 models are an ideal replacement gun for HVLP systems or as a second gun for fast changes between colors, materials etc.
The A711V is a non-bleeder design made for connection to normal shop compressed air. Our venturi system draws in ambient air and mixes it with the incoming compressed air. This results in more volume than comparable guns and provides a cool air source that does not affect materials with critical drying times.
Each of these guns feature all metal construction, a large diameter needle and oversize air passages for high flow and minimal pressure loss . The 710 and 711 guns have wide range of needle/nozzle sizes available; from 0.7mm up to 2.8 mm. For specific nozzle size recommendations, please see Nozzle Chart here.
Materials which can be sprayed include varnish, urethane, lacquer, automotive paint, epoxy, enamel, stain, latex, oil base, multi color etc.
A710 HVLP gun specs:
| A-710S with 1 quart pressure cup |
Order # L080-500 |
| A-710P for pressure feed |
Order # L080-501 |
| Gun Body |
All aluminum, chrome finish |
| Needle and Seat |
Stainless steel, 1.4 mm supplied standard |
| Container ("S" model only) |
1 quart suction, aluminum |
| Air inlet |
Large diameter quick connect for turbine systems |
| Air Pressure and requirements (typical) |
2-10 psi, for connection to 2-4 stage turbine units |
| Fluid inlet (Pressure feed model only) |
3/8" NPS |
| Fluid pressure (typical) |
2-15 psi |
A711V Venturi gun specs:
| A-711S with 1 quart pressure cup |
Order # L080-504 |
| A-711P for pressure feed |
Order # L080-506 |
| Gun Body |
All aluminum, chrome finish |
| Needle and Seat |
Stainless steel, 1.4 mm supplied standard |
| Container (1 quart model only) |
1 quart suction, aluminum |
| Air inlet |
ΒΌ" NPS |
| Air Pressure and requirements (typical) |
6-12 CFM, from 40-90 psi |
| Fluid inlet (Pressure feed model only) |
3/8" NPS |
| Fluid pressure (typical) |
5-20 psi |
