Lemmer Spray Systems Ltd.

The Lemmer Zip Tip is very light and easy to use. Simply rotate the handle to unclog the tip, even under "high pressure" lockup conditions. Remove the tip to easily flush out the spray hose, or to change tip size. It's long life seal withstands all conventional solvents and is  easy to replace if and when necessary. Maximum working pressure is 5000 psi. Available in sizes 0.009 - 0.053

The Lemmer Big Barrel Tip will interchange with most reversible "G" tips found on the market today. Each tip includes a long life steel seal with standard gasket for use with all materials. Maximum working pressure is 5000 psi.

Made of high quality tungsten carbide, these tips produce excellent spray patterns. Flat tips are best suited for fine finishing where a clean gun shut off is imperative. Having the tip orifice so close to the gun shut off valve eliminates "fluid dead space" which is the cause of spitting. Flat tips are also best suited for certain automatic spraying applications.

A built-in pre-atomizer produces a super fine spray pattern at greatly reduced spray pressures. These reduced pressures also reduce overspray and increase system life. Your airless system will produce excellent finishes without air assist. Perfect for all types of fine finishing including automotive paints and lacquers. Orifices are made of high grade tungsten carbide and machined to exacting tolerances. Fits all standard tip retainers.

Hollow cone spray pattern produces a uniform coating on the inside of pipe. The orifice is made of tungsten carbide and the housing is made of stainless steel. It provides dependable spray performance, accurate flow rate, and long operating life. For use in high pressure spray applications and for spraying abrasive suspensions, paints, coatings, etc. Note: This tip fits the Lemmer standard tip retainer #L033-900. To hook-up to a custom spray system use the "tip adapters" and steel braid hose.

 Centering Block (pdf)